thickness ratio

The influences of the number of layers and thickness ratio on the surface residual stresses were studied.

得出了层数和层厚比对叠层复合陶瓷刀具材料残余应力的影响规律。

互联网摘选

Flooding thickness ratio in vertical layer is greater, wells with ultra-high water cut increase.

油层纵向上水淹厚度比例大，特高含水井越来越多。

互联网摘选

Tension stress was introduced at the stainless steel side, and decreases with the increase of thickness ratio.

不锈钢一侧宽度方向应力为拉应力，并随着相对厚度比的增大而减小；

互联网摘选

The results showed: the size of hybrid hazel nuts was positively related with the index of amentum ament cylinder size. The shell thickness of nuts was significantly negatively related with the ratio of cylinder length and central diameter of amentum ament.

结果显示：杂交榛坚果大小和菜荑花序柱体大小的数量性状指标间呈显著正相关，坚果果壳厚度和葇荑花序柱体长度与中部横径的比值呈显著负相关。

互联网摘选

Study of the Optimal Thickness Ratio of the Birefringent Filter

双折射滤光片最佳厚度比的研究

互联网摘选

By experiment and theoretical analysis, the selection of winding angle, thickness ratio and other main parameters is discussed.

通过实验与理论分析，对缠绕倾角、壁厚比等主要参数的选用进行了探讨。

互联网摘选

The relationships of thickness ratio with yield stress and tensile stress of the clad were established.

在传统的混合法则基础上，建立了宽度方向应力与相对厚度比和拉伸应变之间的关系。

互联网摘选

An Artificial Neural Network Model for Prediction of Thickness Ratio of the Rolled Al/ Cu Sheet

黄铜/铝双金属轧后厚比预测的神经网络模型

互联网摘选

The radius to thickness ratio.

径厚比的影响。

互联网摘选

The layer thickness ratio on the composite material of the double metals is one of its important technique targets.

双金属复合材料的厚比是其重要的技术指标之一。

互联网摘选

The Control for Transmission Thickness Ratio and Density with Off-centre Circumferential Exposure Method

偏心周向曝光法透照厚度比和黑度的控制

互联网摘选

The amount of weld-seam movement increases as the thickness ratio increases.

壁厚差异越大，焊缝移动量越大。

互联网摘选

Effect of Thickness Ratio on Formability of Stainless Steel Cladding Aluminum Sheet

厚度比对不锈钢覆铝板成形性能的影响

互联网摘选

While the control of tensile force will adjust the thickness ratio within a small extent.

控制张力可以在较小范围内精确控制复合后厚比.

网络文摘精选

In these structures, the skin/ core thickness ratio has a great influence on the vibration properties.

在这些结构中，表皮层／中心层的厚度比对振动特性有很大影响。

互联网摘选

Research on Depth-thickness Ratio Check of walls With Constructional Columns

带构造柱墙的高厚比验算探讨

互联网摘选

The bending stress has more effect on the limiting height to thickness ratio than the shear stress.

计算表明，连续组合梁负弯矩区钢梁腹板的弹性临界高厚比主要受弯曲应力的影响，其次为剪应力。

互联网摘选

Enriched ore with higher ratio to diameter to thickness is obtained by changing grinder type, medium and speed.

通过改变磨矿方式、介质类型、磨机转速，可获得高径厚比的绢云母；

互联网摘选

Tensile strength and stiffness increase as skin thickness ratio increases.

拉伸强度和硬度随外壳厚度比增加而增加。

互联网摘选

A Further Study on Choosing Gear Lubricant Viscosity Based on Film Thickness Ratio

基于膜厚比选用齿轮润滑油粘度的再研究

互联网摘选

Propotioning of positive and negative material and grid thickness ratio;

正、负极板栅及活物质的配比；

互联网摘选

Effect of core ∶ dentin thickness ratio on the flexure strength of IPS Empress heat-pressed all-ceramic restorative material.

基底瓷与饰瓷的厚度比对IPSEmpress热压铸陶瓷抗弯强度的影响.

互联网摘选

Influence of tension on Aluminum foil profile under large width to thickness ratio

张力对大宽厚比铝箔板形的影响

互联网摘选

It is clear that increases adherend thickness or Poisson ratio as well as decreases the elastic modulus may decrease the peck value of Von Mises equivalent stress.

分析可知：高的泊松比、低弹性模量和被粘物厚的增大会使得VON MISES等效应力值显著降低。

互联网摘选

Briefly Analyzing the Checking Calculation of Height/ Thickness Ratio for Wall and Column of Masonry Structure

浅析砌体结构墙、柱高厚比的验算

互联网摘选

Optimal layer thickness ratio for optimization of ceramic laminates

强界面陶瓷层状复合材料优化设计的最佳层厚比探讨

互联网摘选

Analyses of wall thickness ratio γ of pipe under stretch reducing

张力减径壁厚系数γ辨析

互联网摘选

Two questions in height thickness ratio calculating

高厚比验算的两个问题

互联网摘选

The limitation of web depth-thickness ratio and shear resistance of portal frame tapered girder

门式刚架变截面楔形梁腹板高厚比的限值及抗剪承载力

互联网摘选

Optimum film thickness ratio of the tapered flat thrust bearing with both edge seals

双封油边斜-平面瓦块止推轴承的最佳膜厚比

互联网摘选